Hyundai Santa Fe: High mounted stop lamp replacement
1.Open the tailgate.
2.Gently remove the center cover of the rear tailgate trim.
3.Disconnect the electrical connector.
4.Loosen the retaining nuts and remove the spoiler.
5.Remove the high mounted stop lamp assembly (A) after loosening the nuts and
washer nozzle (B).
6.Reinstall a new lamp assembly in the reverse order of removal.
Inside lamp
1. Open the tailgate. 2. Remove the service cover using a flat-blade screwdriver. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with ...
License plate lamp bulb replacement
1. Loosen the lens retaining screws with a screwdriver. 2. Remove the lens. 3. Remove the bulb. 4. Install a new bulb. 5. Reinstall the lens securely with the lens retaining screws. ...
See also:
Side Airbag (SAB) Module. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least 3 minutes before beginning work. 2. Remove the front seat assembly. 3. Remove the seat back assembly. The side airbag cannot be disassembled ...
Rear Driveshaft. Components and Components Location
Components 1. Tone wheel 2. BJ joint 3. BJ boot 4. BJ boot big part band 5. BJ boot small part band 6. Shaft 7. TJ boot small part band 8. TJ boot big part band 9. TJ boot 10. Snap ring 11. Circlip 12. ...
Relay Box (Engine Compartment). Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Pull out the relay from the engine compartment relay box. Power Relay (Type A) Check for continuity between the terminals. A : Power outlet ...
