Hyundai Santa Fe (DM): Owner’s responsibility - Maintenance services - MaintenanceHyundai Santa Fe (DM): Owner’s responsibility

✽ NOTICE

Maintenance Service and Record Retention are the owner's responsibility.

You should retain documents that show proper maintenance has been performed on your vehicle in accordance with the scheduled maintenance service charts shown on the following pages. You need this information to establish your compliance with the servicing and maintenance requirements of your vehicle warranties.

Detailed warranty information is provided in your Owner’s Handbook & Warranty Information booklet.

Repairs and adjustments required as a result of improper maintenance or a lack of required maintenance are not covered.

We recommend you have your vehicle maintained and repaired by an authorized HYUNDAI dealer. An authorized HYUNDAI dealer meets HYUNDAI’s high service quality standards and receives technical support from HYUNDAI in order to provide you with a high level of service satisfaction.

Maintenance services
You should exercise the utmost care to prevent damage to your vehicle and injury to yourself whenever performing any maintenance or inspection procedures. Should you have any doubts concerning the inspection ...

Owner maintenance precautions
Improper or incomplete service may result in problems. This section gives instructions only for the maintenance items that are easy to perform. As explained earlier in this section, several procedures ...

See also:

Instrument Cluster. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel (A). 3. Remove the cluster (A) from the housing after removing 2 screws. 4. Disconnect the cluster connecter ...

Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the If there is no CKPS signal input, the engine may stop because of CKPS signal ...

Engine compartment panel fuse replacement
1. Turn the ignition switch and all other switches off. 2. Remove the fuse box cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or insert the fuse, ...