Hyundai Santa Fe: If you have a flat tire while driving - In case of an emergency while driving - What to do in an emergencyHyundai Santa Fe: If you have a flat tire while driving

If a tire goes flat while you are driving:

1. Take your foot off the accelerator pedal and let the car slow down while driving straight ahead. Do not apply the brakes immediately or attempt to pull off the road as this may cause a loss of control. When the car has slowed to such a speed that it is safe to do so, brake carefully and pull off the road. Drive off the road as far as possible and park on firm, level ground. If you are on a divided highway, do not park in the median area between the two traffic lanes.
2. When the vehicle is stopped, turn on your emergency hazard flashers, set the parking brake and put the transaxle in P.
3. Have all passengers get out of the car. Be sure they all get out on the side of the car that is away from traffic.
4. When repairing a flat tire, follow the instruction provided later in this section.

If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. ...

If engine stalls while driving
1. Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. 2. Turn on your emergency flashers. 3. Try to start the engine again. If your vehicle will not start, ...

See also:

Components and Components Location
Component Location 1. Windshield deicer relay (Built-in engine room relay box) 2. Windshield deicer switch (Dual type) 3. Windshield deicer switch (Manual type) 4. Windshield deiecr 5. Deicer connector ...

To use the cargo security screen
1. Pull the cargo security screen towards the rear of the vehicle by the handle (1). 2. Insert the guide pin into the guide (2). ✽ NOTICE Pull out the cargo security screen with the handle in the ...

Direct Electro Hydraulic Actuator Coupling. Components and Components Location
Component Location 1. Coupling assembly 2. Propeller shaft 3. Transfer assembly Components 1. Coupling assembly 2. Input shaft 3. Pressure sensor 4. Extension wiring 5. Oil hydraulic Motor(Actuator) ...