Hyundai Santa Fe: If engine stalls while driving - In case of an emergency while driving - What to do in an emergencyHyundai Santa Fe: If engine stalls while driving

1. Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place.
2. Turn on your emergency flashers.
3. Try to start the engine again. If your vehicle will not start, contact an authorized HYUNDAI dealer or seek other qualified assistance.

✽ NOTICE

If there was a check engine light and loss of power or stall, it is best if safe to do so to wait at least 10 seconds to restart a vehicle after it stalls. This may reset the car so it will no longer run at low power (limp home) condition.

If you have a flat tire while driving
If a tire goes flat while you are driving: 1. Take your foot off the accelerator pedal and let the car slow down while driving straight ahead. Do not apply the brakes immediately or attempt to pull off ...

See also:

BJ Boot. Repair procedures
Removal 1. Remove the front driveshaft. 2. Remove the TJ joint assembly. 3. Remove the Dynamic damper. 4. Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A). 5. Remove the BJ boot. ...

Passive Occupant Detection System (PODS-F). Components and Components Location
Components ...

Rail Pressure Sensor (RPS). Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. Condition Output Voltage (V) Idle  Approx. 1.2 1,500 rpm ...