Hyundai Santa Fe: Intake Air Temperature Sensor (IATS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Santa Fe: Intake Air Temperature Sensor (IATS). Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Engine Control/Fuel System / Engine Control System / Intake Air Temperature Sensor (IATS). Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”

Intake Air Temperature Sensor (IATS). Schematic Diagrams
Circuit Diagram ...

Engine Coolant Temperature Sensor (ECTS). Description and Operation
Description Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant passage of the cylinder head for detecting the engine coolant temperature. The ECTS uses a thermistor that changes ...

See also:

Shift Cable. Repair procedures
Removal 1. Remove the floor console. 2. Remove the air duct. 3. Disconnect the shift cable (A). 4. Remove the retainer (A) and nut (B). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8~8.7 lb-ft) ...

Seat Heater Switch. Schematic Diagrams
Circuit Diagram ...

35R Clutch Control Solenoid Valve(35R/C_VFS). Specifications
Specifications Direct control VFS[35R/C] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14~9.81 (5.1~0.1,72.54~1.42) Current value(mA) 50~850 Internal resistance(Ω) ...