Hyundai Santa Fe (TM): LCD display messages
Shift to P (for smart key system)
This message is displayed if you try to turn off the vehicle without the gear in the P (Park) position.
If this occurs, the Engine Start/Stop button turns to the ACC position.
Low key battery (for smart key system)
This message is displayed if the battery of the smart key is discharged while changing the Engine Start/Stop button to the OFF position.
Press START button while turning wheel (for smart key system)
This message is displayed if the steering wheel does not unlock normally when the Engine Start/Stop button is pressed.
You should press the Engine Start/Stop button while turning the steering wheel right and left.
Check steering wheel lock system (for smart key system)
This message is displayed if the steering wheel does not lock normally while the Engine Start/Stop button is pressed to the OFF position.
Press brake pedal to start engine (for smart key system)
This message is displayed if the Engine Start/Stop button changes to the ACC position twice by pressing the button repeatedly without depressing the brake pedal.
You can start the vehicle by depressing the brake pedal and then pressing the Engine Start/Stop button.
Key not in vehicle (for smart key system)
This message is displayed if the smart key is not in the vehicle when you leave the vehicle with the Engine Start/Stop button in the ON or Start position.
Always turn off the engine before leaving your vehicle.
Key not detected (for smart key system)
This message is displayed if the smart key is not detected when you press the Engine Start/Stop button.
Press START button again (for smart key system)
This message is displayed if you were unable to start the vehicle when the Engine Start/Stop button was pressed.
If this occurs, attempt to start the engine by pressing the Engine Start/ Stop button again.
If the warning message appears each time you press the Engine Start/Stop button, have the vehicle inspected by an authorized HYUNDAI dealer.
Press START button with key (for smart key system)
This message is displayed if you press the Engine Start/Stop button while the warning message “Key not detected” is displayed.
At this time, the immobilizer indicator light blinks.
Check BRAKE SWITCH fuse (for smart key system)
This message is displayed if the brake switch fuse is disconnected.
You need to replace the fuse with a new one before starting the engine.
If that is not possible, you can start the engine by pressing the Engine Start/ Stop button for 10 seconds in the ACC position.
Shift to P to start engine (for smart key system)
This message is displayed if you try to start the engine in any other position except P (Park).
Battery discharging due to external electrical devices (if equipped)
This message is displayed if the 12V battery voltage is weak due to any non-factory electrical accessories (ex. dashboard camera) while parking. Be careful that the battery is not discharged.
If the message appears after removing the non-factory electrical accessories, have the vehicle inspected by an authorized HYUNDAI dealer.
Door, Hood, Liftgate open indicator
This warning is displayed if any door or hood or liftgate is left open. The warning will indicate which door is open in the display.
CAUTION
Before driving the vehicle, you should confirm that the door/ hood/liftgate are fully closed.
Also, check there is no door/hood/ liftgate open warning light or message displayed on the instrument cluster.
Sunroof open indicator
This warning is displayed if you turn off the engine when the sunroof is open.
Close the sunroof securely before leaving your vehicle.
Low tire pressure
This warning message is displayed if the tire pressure is low. The corresponding tire on the vehicle will be illuminated.
Lights
This indicator displays which exterior light is selected using the lighting control.
You can activate or deactivate Wiper/ Lights display function from the User Settings menu in the cluster LCD display.
Select:
- Setup - User Settings - Cluster - Wiper/Lights display
Wiper
This indicator displays which wiper speed is selected using the wiper control.
You can activate or deactivate Wiper/ Lights display function from the User Settings menu in the cluster LCD display.
Select:
- Setup - User settings - Cluster - Wiper/Lights display
Low washer fluid
This message is displayed if the washer fluid level in the reservoir is nearly empty.
Have the washer fluid reservoir refilled.
Low fuel
This message is displayed if the fuel tank is almost out of fuel.
When this message is displayed, the low fuel level warning light in the cluster will come on.
It is recommended to look for the nearest fueling station and refuel as soon as possible.
Low engine oil (if equipped)
This warning message is displayed when the engine oil level should be checked.
If this warning message is displayed, check the engine oil level as soon as possible and add engine oil as required.
Slowly pour the recommended oil little by little into a funnel.
Use only the specified engine oil. (Refer to "Recommended Lubricants and Capacities“ section in chapter 2.)
Do not overfill the engine oil. Make sure the oil level is not above F (Full) mark on the dipstick.
Engine overheated / Engine has overheated (if equipped)
This message is displayed when the engine coolant temperature is above 248°F (120°C). This means that the engine is overheated and may be damaged.
If your vehicle is overheated, refer to “Overheating” section in chapter 8.
Check exhaust system (if equipped)
This message is displayed if there is a problem with the GPF system. At this time, the GPF warning light will also blink. If this occurs, have the GPF system checked by an authorized HYUNDAI dealer.
GPF : Gasoline Particulate Filter
Check headlight (if equipped)
This warning message is displayed if the headlights are not operating properly.
In addition, if a specific lamp(turn signal lamp etc.) is not operating properly, the warning message according to a specific lamp (turn signal lamp etc.) is displayed. A corresponding bulb may need to be replaced.
Make sure to replace the burned out bulb with a new one of the same wattage rating.
Check turn signal (if equipped)
This message is displayed if the turn signal lamps are not operating properly. A lamp may need to be replaced.
Make sure to replace the burned out bulb with a new one of the same wattage rating.
Check headlight LED (if equipped)
This message is displayed if there is a problem with the LED headlight. Have the vehicle inspected by an authorized HYUNDAI dealer.
Check Forward Collision-Avoidance Assist system (if equipped)
This warning message is displayed if there is a problem with Forward Collision-Avoidance Assist. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “Forward Collision-Avoidance Assist (FCA)” in chapter 6.
Check Lane Keeping Assist system (if equipped)
This warning message is displayed if there is a problem with Lane Keeping Assist. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “Lane Keeping Assist (LKA)” in chapter 6.
Check Blind-Spot Collision Warning system (if equipped)
This warning message is displayed if there is a problem with Blind-Spot Collision Warning. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “Blind-Spot Collision Warning (BCW) ” in chapter 6.
Check Driver Attention Warning system (if equipped)
This warning message is displayed if there is a problem with Driver Attention Warning. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “Driver Attention Warning (DAW)” in chapter 6.
Check High Beam Assist system (if equipped)
This warning message is displayed if there is a problem with the High Beam Assist. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “High Beam Assist (HBA)” in chapter 5.
Check Smart Cruise Control system (if equipped)
This warning message is displayed if there is a problem with Smart Cruise Control. Have the vehicle inspected by an authorized HYUNDAI dealer.
Warning and indicator lights
Information Make sure that all warning lights are OFF after starting the engine. If any light is still ON, this indicates a situation that needs attention. Seat belt warning light. Air bag warning light. ...LCD Display
...See also:
Driving at night
Because night driving presents more hazards than driving in the daylight, here are some important tips to remember: Slow down and keep more distance between you and other vehicles, as it may be more difficult ...
Power outlet
Front Center Rear The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 10 amps with ...
Instrument Cluster. Components
and Components Location
Components Connector Pin Information No. Description No. Description 1 - 21 - 2 Illumination output 22 - 3 Rheostat down switch 23 4P output 4 Rheostat up switch 24 Immobilizer 5 AT N output 25 AT S output ...