Hyundai Santa Fe: Overhead Console Lamp. Repair procedures - Lighting System - Body Electrical SystemHyundai Santa Fe: Overhead Console Lamp. Repair procedures

Inspection

1.
Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.

[General]

[Panorama Sunroof]


Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the mounting screws (2EA).
And then remove the overhead console (A).

3.
Remove the overhead console after disconnect the connector (A).

4.
If it is necessary to replace the bulb, replace the bulb after removing the lens (A).


Installation

1.
Install the overhead console lamp after connecting the connector.
2.
Install the lens after tightening 2 screws.

Room Lamp. Repair procedures
Inspection 1. Remove the room lamp assembly then check for continuity between terminals. [General] [Panorama Sunroof] Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) ...

Door Mood Lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. 3. Disconnect the door mood lamp connectors (A). 4. Remove the door mood lamp (A) after loosening the screws (3EA). ...

See also:

Low Tire Pressure Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When one or more of your ...

Front Door Latch. Repair procedures
Replacement 1. Remove the front door module. 2. Remove the front door outside handle base (A) by pushing in the lock pins located in the back. 3. Open the front door outside handle cable cap (A). 4. Remove ...

Description and Operation
Description The hydraulic system consists of oil, an oil filter, an oil pump, and a valve body (valves and solenoid valves). The oil pump is powered by the engine. ATF passes through the oil filter and ...