Hyundai Santa Fe: Power Seat Motor. Repair procedures
Inspection
Power Seat Motor
| 1. |
Disconnect the connectors for each motor.
A : Slide motor
B : Front height motor
C : Rear height motor
D : Lumbar support motor (Horizontal)
E : Lumbar support motor (Vertical)
F : Recline motor
|
| 2. |
With the battery connected directly to the motor
terminals, check if the motors run smoothly.
|
| 3. |
Reverse the connections and check that the motor
turns in reverse.
|
| 4. |
If there is an abnormality, replace the motors.
[Driver]
[Passenger]
|
Components and Components Location
Component Location 1. Slide motor 2. Front height motor 3. Rear height motor 4. Lumbar support motor (Horizontal) 5. Lumbar support motor (Vertical) 6. Reclining motor 7. Power seat switch 8. Reclining ...
Power Seat Control Switch. Schematic
Diagrams
Circuit Diagram ...
See also:
Good braking practices
WARNING Whenever you leave or park your vehicle, always set the parking brake as far as possible and fully engage the vehicle's transaxle into the P (Park) position. If the parking brake is not fully ...
Specifications
Specifications Purge Control Solenoid Valve (PCSV) ▷ Specification Item Specification Coil Resistance (Ω) 19.0 ~ 22.0 [20°C(68°F)] Fuel Tank Pressure Sensor (FTPS) ▷ Type: Piezo-Resistive ...
Knee Airbag (KAB) Module. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the crash pad lower panel. 3. After loosening the mounting nuts and then remove the ...
