Hyundai Santa Fe: Programming HomeLink® - Mirrors - Features of your vehicleHyundai Santa Fe: Programming HomeLink®

✽ NOTICE

  • When programming a garage door opener, it is advised to park the vehicle outside of the garage.
  • It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink® for quicker training and accurate transmission of the radio-frequency signal.
  • Some vehicles may require the ignition switch to be turned to the second (or "accessories") position for programming and/or operation of HomeLink.
  • In the event that there are still programming difficulties or questions after following the programming steps listed below, contact HomeLink® at: www.homelink.com or 1-800-355-3515.
Compass function
The Compass can be turned ON and OFF and will remember the last state when the ignition is cycled. To turn the display feature ON/OFF: 1. Press and release the button to turn the display feature OFF. 2. ...

Standard programming
To train most devices, follow these instructions: 1. For first-time programming, press and hold the two outside buttons, HomeLink® Channel 1 and Channel 3 Buttons, until the indicator light begins to ...

See also:

CVVT & Camshaft. Repair procedures
Removal 1. Remove the cylinder head cover. 2. Set No.1 cylinder to TDC/compression. A. Turn the crankshaft pulley and align its groove with the timing mark "T" of the lower timing chain cover. ...

Fuel Tank Pressure Sensor (FTPS). Schematic Diagrams
Circuit Diagram ...

Storage compartment
CAUTION To avoid possible theft, do not leave valuables in the storage compartments. Always keep the storage compartment covers closed while driving. Do not attempt to place so many items in the storage ...