Hyundai Santa Fe: Rear Combination Lamp. Repair procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Loose the screws (2EA) holding the rear combination
lamp then disconnect the connector (A) then remove the outside rear
combination lamp (B).
|
| 3. |
If it is necessary to replace the bulb, remove the
rear combination cover (A).
|
| 4. |
Remove the bulb (A) after disconnecting the connector.
|
| 5. |
Remove the tailgate trim.
|
| 6. |
Remove the inside rear combination lamp assembly
(A) after loosening the nuts (4EA) and disconnecting the connector.
|
| 7. |
Remove the bulb (B) after separating the inside rear
combination lamp assembly (A).
|
| 8. |
If it is necessary to replace the bulb, remove the
bulb after removing the tailgate cover.
|
Installation
| 1. |
Install the tailgate combination lamp assembly after
assembling the bulb.
|
| 2. |
Install the lamp cover to the tailgate after connecting
the lamp connector.
|
| 3. |
Install the rear combination lamp assembly after
assembling the bulbs and connecting the lamp connector.
|
Luggage Room Lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp lens (A) with a flat-tip screwdriver after loosening the screws (2EA). 3. Remove the luggage room lamp bulb (A). ...
Troubleshooting
Troubleshooting Symptom Possible cause Remedy One lamp does not light (all exterior) Bulb burned out Replace bulb Socket, wiring or ground faulty Repair if necessary Head lamps do not light Bulb burned ...
See also:
To fold down the rear center seatback
1. Lower the rear headrests to the lowest position. 2. Push the center seatback folding lever up, then fold the seat toward the front of the vehicle. When you return the seatback to its upright position, ...
Hazard warning flasher
Type A Type B The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far ...
Outside lamp
1. Open the tailgate. 2. Remove the service cover using a flat-blade screwdriver. 3. Loosen the lamp assembly retaining please verify. 4. Remove the rear combination lamp assembly from the body of the ...
