Hyundai Santa Fe: Repair procedures
Inspection
| 1. |
Turn the steering wheel so that the front wheels can face straight
ahead.
|
| 2. |
Measure the distance the steering wheel can be turned without
moving the front wheels.
|
| 3. |
If the play exceeds standard value, inspect the steering column,
shaft, and linkages.
|
| 1. |
Position the vehicle on a level surface and place the steering
wheel in the straight ahead position.
|
| 2. |
Attach a spring scale to the With the engine speed 900 ~ 1100rpm,
pull the scale and read it as soon as the tires begin to turn.
|
| 3. |
If the measured value exceeds standard value, inspect the power
steering gear box and MDPS system.
|
Special Service Tools
Special Service Tools Tool (Number and Name) IIIustration Use 09561-11001 Steering wheel puller Remove the steering wheel ...
Steering wheel
...
See also:
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Automatic Transaxle. Components and Components Location
Components Location 1. Automatic transaxle 2. Shift cable bracket 3. Inhibitor switch connector 4. Manual control lever 5. Automatic transaxle mounting support bracket 6. Solenoid valve connector 7. ATF ...
High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back for low beams. The high beam indicator will light when the headlight high beams are switched on. To prevent the battery ...
