Hyundai Santa Fe: Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Santa Fe: Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures

Inspection

1.
Turn ignition switch OFF.
2.
Remove the air duct.
3.
Disconnect the solenoid valve connector(A).

4.
Measure resistance between sensor signal terminal and sensor ground terminal.
5.
Check that the resistance is within the specification.

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.

SS-A Solenoid Valve(ON/OFF). Description and Operation
Description SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body. ...

See also:

Rear Hub - Carrier. Components and Components Location
Components 1. Rear carrier assembly 2. Parking brake assembly 3. Rear hub assembly 4. Rear brake disc ...

Flex Steer. Components and Components Location
Components Location 1. Flex steer switch ...

Seat Belt Buckle Switch (BS). Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The ...