Hyundai Santa Fe: Seat Heater (Non-Air Ventilation). Repair procedures - Seat Electrical - Body Electrical SystemHyundai Santa Fe: Seat Heater (Non-Air Ventilation). Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body Electrical System / Seat Electrical / Seat Heater (Non-Air Ventilation). Repair procedures

Inspection

Front Seat
1.
Check for continuity and measure the resistance between terminals.

No.
 Description
No.
 Description
1
 Heater cushion +
4
 Heater back +
2
 NTC +
5
 -
3
 Ground
6
 NTC -

Standard value (Fabric / Leather)
Cushion : 3.90 Ω ± 10%
Back : 5.52 Ω ± 10%
Set : 9.42 Ω ± 10%
2.
Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.

 1st
 2nd
 3rd
Cushion
(± 2°C)
 36
 39
 42
Back
(± 2°C)
 40
 45
 50

Second Seat
1.
Check for continuity and measure the resistance between terminals.
[Rear Seat (RH)]

[Rear Seat (LH)]

No.
 Description
No.
 Description
1
 Heater -
3
 NTC +
2
 NTC -
4
 Heater +

Standard value (Fabric / Leather)
Cushion : 1.19 Ω ± 10%
Back : 1.05 Ω ± 10%
Set : 2.24 Ω ± 10%
2.
Operate the seat heater after connecting the connector, and then check the thermostat by measuring the temperature of seat surface.
Standard value
Cushion : 36.2±2°C(LOW)/ 69.0±2°C(HIGH)
Back : 40.0±2°C(LOW)/ 45.0±2°C(HIGH)

Seat Heater (Non-Air Ventilation). Schematic Diagrams
Circuit Diagram ...

Seat Heater (Air Ventilation). Components and Components Location
Components ...

See also:

Specifications
Specifications Smart Key Unit Items Specification Rated voltage DC 12V Operating voltage DC 9 ~ 16V Operating temperature -22°F ~ 167°F (-30°C ~ 75°C) Load Max. 2.9mA (When welcome light function off) ...

Active ECO operation
Active ECO helps improve fuel efficiency by controlling certain engine and transaxle system operating parameters. Fuel efficiency depends on the driver's driving habit and road condition. When the ...

Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. 3. Remove the steering column upper and lower shrouds (A) after removing 3 screws. 4. Disconnect the light switch ...