Hyundai Santa Fe: Service Mode
Service Interval
Service in
It calculates and displays when you need a scheduled maintenance service (mileage or days).
If the remaining mileage or time reaches 900 mi. (1,500 km) or 30 days, "Service in" message is displayed for several seconds each time you set the ignition switch or Engine Start/Stop Button to the ON position.
Service required
If you do not have your vehicle serviced according to the already inputted service interval, “Service required” message is displayed for several seconds each time you set the ignition switch or Engine Start/Stop Button to the ON position (The mileage and time changes to "---").
To reset the service interval to the mileage and days you inputted before:
- Press the SELECT/RESET button for more than 1 second.
Service in OFF
If the service interval is not set, “Service in OFF” message is displayed on the LCD display.
✽ NOTICE
If any of the following conditions occurs, the mileage and days may be incorrect.
- The battery cable is disconnected.
- The fuse switch is turned off.
- The battery is discharged.
LCD Modes
❈ For controlling the LCD modes, refer to "LCD Display Control" in this chapter. ❈ For "Trip Computer" mode, refer to "Trip Computer" in this chapter. ...
User Settings Mode
Description On this mode, you can change setting of the doors, lamps, and so on. Door Auto Door Lock (if equipped) • Off: The auto door lock operation will be deactivated. • Speed: All doors will be ...
See also:
Troubleshooting
Troubleshooting Problem Symptoms Table Use the table below to help you find the cause of the problem. The numbers indicate the priority of the like cause of the problem. Check each part in order. If necessary, ...
Tire specification and pressure label
The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center pillar gives the tire pressures recommended ...
Manual heating and air conditioning
The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of buttons ...
