Hyundai Santa Fe: Special Service Tools - General Information - RestraintHyundai Santa Fe: Special Service Tools

Special Service Tools

Tool(Number and Name)
Illustration
Use
Deployment tool
0957A-34100A

Airbag deployment tool.
Deployment adapter
0957A-3F100

Use with deployment tool.
(KAB)
Deployment adapter
0957A-2W100

Use with deployment tool.
(SAB)
Deployment adapter
0957A-3Q100

Use with deployment tool.
(DAB, PAB, CAB, BPT, EFD)
Dummy
0957A-38200

Simulator to check the resistance of each wiring harness.
Dummy adapter
0957A-3F000

Use with dummy.
(KAB)
Dummy adapter
0957A-2W200

Use with dummy.
(SAB)
Dummy adapter
0957A-2G000

Use with dummy.
(DAB, PAB, CAB, BPT, EFD)

DAB : Driver Airbag
PAB : Passenger Airbag
SAB : Side Airbag
CAB : Curtain Airbag
KAB : Knee Airbag
BPT : Seat Belt Pretensioner
EFD : Emergency Fastening Device

Specifications
Tightening Torques Item N.m kgf.m lb-ft Passenger airbag(PAB) 7.8 ~ 11.8 0.8 ~ 1.2 5.8 ~ 8.7 Curtain airbag (CAB) Bolt 7.8 ~ 10.8 0.8 ~ 1.2 5.8 ~ 8.7 Nut 3.9 ~ 5.9 0.4 ~ 0.6 2.9 ~ 4.3 Knee airbag (KAB) ...

General Safety Information and Caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally ...

See also:

Rear Center Seat Belt Retractor. Repair procedures
Replacement • When installing the belt, make sure not to damage the retractor. 1. Remove the second row seat back cover [LH]. 2. Loosen the rear center seat belt lower anchor mounting bolt (A). Tightening ...

Immobilizer Indicator Light (Without Smart Key)
This indicator light illuminates: • When the vehicle detects the immobilizer in your key properly while the ignition switch is ON. - At this time, you can start the engine. - The indicator light goes ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...