Hyundai Santa Fe: To temporarily accelerate with the cruise control on
If you want to speed up temporarily when the cruise control is on, depress the accelerator pedal. Increased speed will not interfere with cruise control operation or change the set speed.
To return to the set speed, take your foot off the accelerator pedal.
To decrease the cruising speed
Follow either of these procedures: Move the lever down (to SET-) and hold it. Your vehicle will gradually slow down. Release the lever at the speed you want to maintain. Move the lever down (to SET-) ...
To cancel cruise control, do one of the following
Depress the brake pedal. Shift into N (Neutral) with an automatic transaxle. Press the CANCEL switch located on the steering wheel. Decrease the vehicle speed lower than the memory speed by 9 mph (15 ...
See also:
Specifications
Specifications Items Specifications Rated voltage DC 12V Operating temperature range -22 ~ +176°F (-30°C ~ +80°C) Rated load Dimmer & passing switch High : 0.2A (Relay load) Low : 0.2A (Relay load) ...
In the event of brake failure
If service brakes fail to operate while the vehicle is in motion, you can make an emergency stop with the parking brake. The stopping distance, however, will be much greater than normal. WARNING - Parking ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
