Hyundai Santa Fe: To decrease the cruising speed
Follow either of these procedures:
- Move the lever down (to SET-) and hold it. Your vehicle will gradually slow down. Release the lever at the speed you want to maintain.
- Move the lever down (to SET-) and release it immediately.
The cruising speed will decrease by 1 mph (1.6 km/h) each time you move the lever down (to SET-) in this manner.
To increase cruise control set speed
Follow either of these procedures: Move the lever up (to RES+) and hold it.Your vehicle will accelerate. Release the lever at the speed you want. Move the lever up (to RES+) and release it immediately. ...
To temporarily accelerate with the cruise control on
If you want to speed up temporarily when the cruise control is on, depress the accelerator pedal. Increased speed will not interfere with cruise control operation or change the set speed. To return to ...
See also:
Height Adjust. Repair procedures
Replacement 1. Remove the front seat belt upper anchor. 2. After loosening the mounting bolts, then remove the height adjust (A). Tightening torque : 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft) ...
SS-A Solenoid Valve(ON/OFF). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Driver Airbag (DAB) Module and Clock Spring. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag module by putting in a flat tool (Ø5mm) into the guide hole ...
