Hyundai Santa Fe: TPMS (Tire Pressure Monitoring System) malfunction indicator

The TPMS malfunction indicator will illuminate after it blinks for approximately one minute when there is a problem with the Tire Pressure Monitoring System. If the system is able to correctly detect an under inflation warning at the same time as system failure then it will illuminate the TPMS malfunction indicator.
Have the system checked by an authorized HYUNDAI dealer as soon as possible to determine the cause of the problem.
CAUTION
- The TPMS malfunction indicator may be illuminated if the vehicle is moving around electric power supply cables or radios transmitter such as at police stations, government public offices, broadcasting stations, military installations, airports, or transmitting towers, etc. This can interfere with normal operation of the Tire Pressure Monitoring System (TPMS).
- The TPMS malfunction indicator may illuminate if snow chains or some separately purchased devices such as notebook computers, mobile charger, remote starter, navigation etc. are used in the vehicle. This can interfere with normal operation of the Tire Pressure Monitoring System (TPMS).
Low tire pressure indicator
When the tire pressure monitoring system warning indicator is illuminated, one or more of your tires is significantly under-inflated. If the indicator illuminates, immediately reduce your speed, avoid ...
Changing a tire with TPMS
If you have a flat tire, the Low Tire Pressure indicator will come on. Have the flat tire repaired by an authorized HYUNDAI dealer as soon as possible or replace the flat tire with the spare tire. CAUTION ...
See also:
Flex Steer. Repair procedures
Inspection 1. Check the audio remote control switch (A) for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Cancel 2-7 180 Ω Set 2-7 330 Ω ...
Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is a malfunction ...
26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
