Hyundai Santa Fe: Start/Stop Button. Repair 
procedures - Button Engine Start System - Body Electrical SystemHyundai Santa Fe: Start/Stop Button. Repair procedures

Removal

1.
Disconnect the negative(-) battery terminal.
2.
Remove the driver crash pad lower panel.
3.
Disconnect the start/stop button connector (B) after removing the center fascia garnish (A).

4.
Remove the start/stop button (A) after removing the screws (3EA).


Installation

1.
Install the start/stop button.
2.
Install the crash pad lower panel.
3.
Connect the negative (-) battery terminal.

See also:

Headlamp delay
If you turn the ignition switch to the ACC or OFF position with the headlights ON, the headlights remain on for about 5 minutes. However, if the driver’s door is opened and closed, the headlights are ...

Seat belt warning (for driver’s seat)
The driver's seat belt warning light and chime will activate to the following table when the ignition switch is in "ON" position. *1Warning pattern repeats 11 times with an interval of 24 ...

Closing the hood
1. Before closing the hood, check the following: All filler caps in engine compartment must be correctly installed. Gloves, rags or any other combustible material must be removed from the engine compartment. ...