Hyundai Santa Fe: Underdrive Brake Control Solenoid Valve(UD/B_VFS). Repair procedures
Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the air duct.
|
| 3. |
Disconnect the solenoid valve connector(A).
|
| 4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 5. |
Check that the resistance is within the specification.
|
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
|
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Schematic Diagrams
Circuit Diagram ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Description and Operation
Description Overdrive clutch control solenoid valve(OD/C) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the overdrive clutch. ...
See also:
Front Fog Lamps. Repair procedures
Inspection Front Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction ...
Filter replacement
1. Open the glove box and remove the support strap (1). 2. With the glove box open, remove the stoppers on both sides. 3. Remove the climate control air filter case by pulling out both sides of the cover. ...
Engine coolant
The high-pressure cooling system has a reservoir filled with year-round antifreeze coolant. The reservoir is filled at the factory. Check the antifreeze protection and coolant concentration level at least ...
