Hyundai Santa Fe: Front Fog Lamps. Repair procedures
Inspection
Front Fog Lamp Switch
| 1. |
With the fog lamp switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace the multifunction switch.
|
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front bumper.
|
| 3. |
Remove the front fog lamp assembly (A) after loosening
the mounting screws (4EA).
|
| 4. |
Remove the front fog lamp (A) by turning in the counter
clock-wise direction after disconnecting the connector.
|
Installation
| 1. |
Install the front fog lamp bulb.
|
| 2. |
Connect the front fog lamp connector.
|
| 3. |
Install the front bumper.
|
Rheostat. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad side cover. 3. Remove the lower crash pad switch assembly (A) after loosening the screws (3EA). 4. Remove the rheostat ...
License Lamps. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens (A) from the panel after loosening a screw. 3. Replace the bulb (B) after removing the license lamp (A). Installation ...
See also:
Driver's and passenger's front air bag
Your vehicle is equipped with a Supplemental Restraint (Air Bag) System and the lap/shoulder belts at both the driver and passenger seating positions. The indications of the system's presence are ...
Front Door Inside Handle. Repair procedures
Replacement 1. Remove the front door trim. 2. After loosening the mounting screws, then remove the front door inside handle (A). 3. Install in the reverse order of removal. • Make sure the door locks/unlocks ...
Battery. Troubleshooting
Troubleshooting ...
