Hyundai Santa Fe: Front Seat Belt Pretensioner. Repair procedures - Front Seat Belt - Body (Interior and Exterior)Hyundai Santa Fe: Front Seat Belt Pretensioner. Repair procedures

Replacement

•
When installing the belt, make sure not to damage the pretensioner.
1.
Remove the center pillar upper trim.
2.
After loosening the mounting bolt, then remove the front seat belt upper anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)
гид экскурсовод обучение

3.
Loosen the mounting bolts, and remove the front seat belt pretensioner (B).
4.
Disconnect the pretensioner connector lock pin, and remove the front seat belt pretensioner connector (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

5.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Front Seat Belt Pretensioner. Components and Components Location
Component Location 1. Front seat belt pretensioner ...

Height Adjust. Components and Components Location
Component Location 1. Height adjust ...

See also:

Cross Member. Body Repair
Front Cross Member * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Rear Cross Member * These dimensions indicated in this figure are actual-measurement ...

Inhibitor Switch. Repair procedures
Inspection • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Power Circuit Inspection 1. Disconnect the Inhibitor swtich connector. ...

Rear Center Seat Belt Retractor. Components and Components Location
Component Location 1. Rear center seat belt retractor ...