Hyundai Santa Fe: Repair procedures - Back View Camera System - Body Electrical SystemHyundai Santa Fe: Repair procedures

Removal

1.
Remove the tailgate trim.
2.
Remove the tailgate back panel.
3.
Disconnector the connector (A) from the back view camera.
4.
Remove the back view camera (B) after loosening the screws (2EA).

Installation

1.
Install the back view camera.
2.
Install the tailgate back panel and tailgate trim.

Description and Operation
Description Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle ...

Hyundai Santa Fe DM 2013-2018 Owner's Manual
Owners Manual for Third generation (DM) Hyundai Santa Fe. Hyundai launched its third-generation seven-seat Santa Fe here in September 2012 to do battle with the big players in the competitive large-SUV ...

See also:

Fuel Tank Pressure Sensor (FTPS). Schematic Diagrams
Circuit Diagram ...

Drive Plate. Repair procedures
Removal and Installation 1. Remove the automatic transaxle . 2. Remove the drive plate (A) and the adapter plate (B). Tightening torque : 117.7 ~ 127.5 N.m (12 ~ 13 kgf.m, 86.8 ~ 94.0 lb-ft) • Always ...

Windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuously if the lever is ...