Hyundai Santa Fe: Rear Center Seat Belt Retractor. Repair procedures - Rear Seat Belt - Body (Interior and Exterior)Hyundai Santa Fe: Rear Center Seat Belt Retractor. Repair procedures

Replacement

•
When installing the belt, make sure not to damage the retractor.
1.
Remove the second row seat back cover [LH].
2.
Loosen the rear center seat belt lower anchor mounting bolt (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
After loosening the mounting nut (B), then remove the rear center seat belt retractor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
Install in the reverse order of removal.
•
Replace any damaged clips.

Rear Center Seat Belt Retractor. Components and Components Location
Component Location 1. Rear center seat belt retractor ...

Rear Seat Belt Buckle. Components and Components Location
Component Location [Second row seat belt buckle] 1. Second row seat belt buckle [LH] 2. Second row center seat belt buckle 3. Second row seat belt buckle [RH] [Third row seat belt buckle] 1. Third row ...

See also:

Yaw-rate and G Sensor. Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. 4. Loosen the bolts ...

General Information
General Troubleshooting Information Before Troubleshooting 1. Check applicable fuses in the appropriate fuse/relay box. 2. Check the battery for damage, state of charge, and clean and tight connections. ...

Rear Door Trim. Components and Components Location
Component Location 1. Rear door trim ...