Hyundai Santa Fe: 35R Clutch Control Solenoid Valve(35R/C_VFS). Repair procedures
Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the air duct.
|
| 3. |
Disconnect the solenoid valve connector(A).
|
| 4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 5. |
Check that the resistance is within the specification.
|
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
|
35R Clutch Control Solenoid Valve(35R/C_VFS). Schematic Diagrams
Circuit Diagram ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Description and Operation
Description Underdrive brake control solenoid valve(UD/B) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the underdrive brake. ...
See also:
Downhill Brake Control (DBC) Indicator Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you activate the DBC ...
Front Seat Shield Outer Cover. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
Service Mode
Service Interval Service in It calculates and displays when you need a scheduled maintenance service (mileage or days). If the remaining mileage or time reaches 900 mi. (1,500 km) or 30 days, "Service ...
