Hyundai Santa Fe: Accelerator Position Sensor (APS). Repair procedures
Inspection
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Turn the ignition switch ON.
|
| 3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Accelerator Position Sensor (APS). Schematic Diagrams
Circuit Diagram ...
Fuel Tank Pressure Sensor (FTPS). Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solenoid ...
See also:
Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). Green arrow indicators on the instrument panel indicate which turn signal is ...
Floor mat anchor(s)
When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward. WARNING The floor mat must be properly ...
Rear Door Module. Repair procedures
Replacement 1. Remove the rear door window glass. 2. Remove the rear door outside handle. 3. Disconnect the rear door main connector (A). 4. Loosen the rear door outside handle base mounting bolt (A). ...
