Hyundai Santa Fe (DM): Assist Handle. Repair procedures - Roof Trim - Body (Interior and Exterior)Hyundai Santa Fe (DM): Assist Handle. Repair procedures

Replacement

Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the caps (A) and screws, then remove the assist handle (B).

2.
Install in the reverse order of removal.

Assist Handle. Components and Components Location
Component Location 1. Assist handle ...

Roof Trim Assembly. Components and Components Location
Component Location 1. Roof Trim Assembly ...

See also:

Direct Electro Hydraulic Actuator Coupling. Components and Components Location
Component Location 1. Coupling assembly 2. Propeller shaft 3. Transfer assembly Components 1. Coupling assembly 2. Input shaft 3. Pressure sensor 4. Extension wiring 5. Oil hydraulic Motor(Actuator) ...

Wipers and washers
A :Wiper speed control · MIST – Single wipe · OFF – Off · INT – Intermittent wipe · LO – Low wiper speed · HI – High wiper speed B : Intermittent wipe time adjustment C :Wash with brief ...

Emergency Fastening Device (EFD). Repair procedures
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. To remove the locking mechanism (A), using a (-) driver (B) turn it counter clockwise. From ...