Body (Interior and Exterior)

Hyundai Santa Fe: Body (Interior and Exterior)

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior)

General Information

Body Dimensions

Fender

Hood

Tail Gate

Fuel Filler Door

Front Door

Rear Door

Body Side Molding

Panorama sunroof

Mirror

Cowl Top Cover

Floor Console

Crash Pad

Roof Trim

Interior Trim

Trunk Trim

Repair procedures

Windshield Glass

Quarter Fixed Glass

Floor Carpet

Repair procedures

Front Bumper

Rear Bumper

Front Seat

Rear Seat

Front Seat Belt

Rear Seat Belt

Steering Angle Sensor. Description and Operation

Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction ...

General Information

...

See also:

Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be held to ...

Closing the hood
1. Before closing the hood, check the following: All filler caps in engine compartment must be correctly installed. Gloves, rags or any other combustible material must be removed from the engine compartment. ...

Fuel Filler Door Open Switch. Repair procedures
Inspection 1. Remove the front door trim. 2. Disconnect the switch connector (A) from wiring. 3. Check the switch for continuity between the No. 1 and No. 2 terminals. If the continuity is not as specified, ...