Hyundai Santa Fe: ATF Warmer. Repair procedures - Hydraulic System - Automatic Transaxle SystemHyundai Santa Fe: ATF Warmer. Repair procedures

Removal

1.
Drain the coolant.
2.
Remove the air cleaner assembly and air duct.
3.
Remove the battery and battery tray.
4.
Remove the under cover(A).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

5.
Disconnect the coolant hose (B) after removing the coolant hose clamp (A).
6.
Disconnect the hose (B) after removing the automatic transaxle fluid cooler hose clamp (A).

When hose&pipe assembly
Align marking of pipe(B), marking of hose(A), and matching color each other.
7.
Remove the ATF Warmer (A).
Tightening torque:
(A)7.8~11.8N.m(0.8 ~ 1.2 kgf.m, 5.8~8.7lb-ft)


Installation

1.
Installation is the reverse of removal.
•
Adding automatic transaxle fluid.
•
Adding coolant.

ATF Warmer. Components and Components Location
Component Location 1. ATF Warmar 2. Bypass valve 3. ATF hose&pipe 4. Coolant hose&pipe Component 1. ATF Warmar 2. Bypass valve 3. ATF hose&pipe 4. Coolant hose&pipe ...

Clutch & Brake
...

See also:

Rear Coil Spring. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

Flex Steer. Repair procedures
Inspection 1. Check the audio remote control switch (A) for resistance between terminals in each switch position. Switch Connector terminal Resistance (±5%) Cancel 2-7 180 Ω Set 2-7 330 Ω ...

Smart Key Unit. Repair procedures
Removal Smart Key Unit 1. Disconnect the negative (-) battery terminal. 2. Remove the driver crash pad lower panel. 3. Remove the smart key unit (B) after loosening the mounting bolts(2EA) and disconnecting ...