Hyundai Santa Fe: Basic Service Symbols - General InformationHyundai Santa Fe: Basic Service Symbols

Basic Service Symbols

There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service.
Symbol
Meaning

Do not reuse the part. Replace a new one.

Apply engine oil or transmission oil to the part.

Apply automatic transmission fluid (ATF) to the part.

Apply grease to the part.

Apply sealant to the part.


General Tightening Torque Table
General Tightening Torque Table Bolt nominal diameter (mm) Pitch (mm) Torque Nm (kg.cm, lb.ft) Head Mark 4 Head Mark 7 M5 0.8 3 ~ 4 (30 ~ 40, 2.2 ~ 2.9) 5 ~ 6 (50 ~ 60, 3.6 ~ 4.3) M6 1.0 5 ~ 6 (50 ~ 50, ...

General Service Information
General Service Information Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. The support rod must be inserted into the hole near the edge of the hood ...

See also:

Hood Weatherstrip. Repair procedures
Replacement 1. Remove the hood weatherstrip (A). • Be careful not to scratch the hood weatherstrip. 2. Install in the reverse order of removal. ...

Windshield wipers
Operates as follows when the ignition switch is turned ON. MIST : For a single wiping cycle, move the lever to this (MIST) position and release it. The wipers will operate continuously if the lever is ...

How vehicle audio works
AM and FM radio signals are broadcast from transmitter towers located around your city. They are intercepted by the radio antenna on your vehicle. This signal is then processed by the radio and sent to ...