Hyundai Santa Fe: Battery replacement

The transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gently pry open the transmitter center
cover.
2. Replace the battery with a new battery (CR2032). When replacing the battery,
make sure the battery position.
3. Install the battery in the reverse order of removal.
For replacement transmitters, see an authorized HYUNDAI dealer for transmitter reprogramming.
- The transmitter is designed to give you years of trouble-free use, however it can malfunction if exposed to moisture or static electricity. If you are unsure how to use your transmitter or replace the battery, contact an authorized HYUNDAI dealer.
- Using the wrong battery can cause the transmitter to malfunction. Be sure to use the correct battery.
- To avoid damaging the transmitter, don't drop it, get it wet, or expose it to heat or sunlight.
- An inappropriately disposed
battery can be harmful
to the environment and may cause human health. Dispose the battery according
to your local law(s) or regulation.
CAUTION - Transmitter damage
Do not drop, wet or expose the keyless entry system transmitter to heat or sunlight.
Transmitter precautions
✽ NOTICE The transmitter will not work if any of following occur: The ignition key is in the ignition switch. You exceed the operating distance limit (about 90 feet [30 m]). The battery in the transmitter ...
Immobilizer system
Your vehicle is equipped with an electronic engine immobilizer system to reduce the risk of unauthorized vehicle use. Your immobilizer system is comprised of a small transponder in the ignition key and ...
See also:
Parking Brake Pedal Assembly. Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the junction box. 4. Disconnect the parking brake switch connector. 5. ...
Repair procedures
Adjustment Glass Adjustment • Check the glass run channel for damage or deterioration, and replace them if necessary. 1. Remove the rear door trim. 2. Remove the rear door window glass mounting hole ...
Power Window Motor. Schematic Diagrams
Circuit Diagram ...
