Hyundai Santa Fe: Transmitter precautions - Folding key - Features of your vehicleHyundai Santa Fe: Transmitter precautions

✽ NOTICE

The transmitter will not work if any of following occur:

  • The ignition key is in the ignition switch.
  • You exceed the operating distance limit (about 90 feet [30 m]).
  • The battery in the transmitter is weak.
  • Other vehicles or objects may be blocking the signal.
  • The weather is extremely cold.
  • The transmitter is close to a radio transmitter such as a radio substation or an airport which can interfere with normal operation of the transmitter.

When the transmitter does not work correctly, open and close the door with the ignition key. If you have a problem with the transmitter, contact an authorized HYUNDAI dealer.

• If the transmitter is in close proximity to your mobile phone, the signal could be blocked by your mobile phones normal operational signals. This is especially important when the phone is active such as making and receiving calls, text messaging, and/or sending/receiving emails. Avoid placing the transmitter and your mobile phone in the same pants or jacket pocket and always try to maintain an adequate distance between the two devices.

CAUTION

Keep the transmitter away from water or any liquid. If the keyless entry system is inoperative due to exposure to water or liquids, it will not be covered by your manufacturer’s vehicle warranty.

Key operations
Used to start the engine. Used to lock and unlock the doors. Used to lock and unlock the glove box. To unfold the key, press the release button then the key will unfold automatically. To fold the key, ...

Battery replacement
The transmitter uses a 3 volt lithium battery which will normally last for several years. When replacement is necessary, use the following procedure. 1. Insert a slim tool into the slot and gently pry ...

See also:

Air conditioning
Press the A/C button to turn the air conditioning system on (indicator light will illuminate). Press the button again to turn the air conditioning system off. ...

Power Door Mirror Actuator. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (B) after removing the front door quadrant cover (A). 3. Disconnect the power door mirror connector (A) from the ...

Rear Differential Carrier. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the front ...