Hyundai Santa Fe: Closing the hood - Hood - Features of your vehicleHyundai Santa Fe: Closing the hood

1. Before closing the hood, check the following:

  • All filler caps in engine compartment must be correctly installed.
  • Gloves, rags or any other combustible material must be removed from the engine compartment.

2. Lower the hood halfway and push down to securely lock in place.

WARNING

  • Before closing the hood, ensure that all obstructions are removed from the hood opening. Closing the hood with an obstruction present in the hood opening may result in property damage or severe personal injury.
  • Do not leave gloves, rags or any other combustible material in the engine compartment. Doing so may cause a heatinduced fire.
  • Always double check to be sure that the hood is firmly latched before driving away. If it is not latched, the hood could open while the vehicle is being driven, causing a total loss of visibility, which might result in an accident.
  • Do not move the vehicle with the hood in the raised position, as vision is obstructed and the hood could fall or be damaged.
Opening the hood
1. Pull the release lever to unlatch the hood. The hood should pop open slightly. WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P(Park) position, ...

See also:

Components and Components Location
Components 2WD 1. Rear upper arm 2. Rear stabilizer bar 3. Rear lower arm 4. Rear assist arm 5. Rear shock absorber 6. Rear cross member 7. Trailing arm 4WD 1. Rear assist arm 2. Rear cross member 3. Rear ...

Roof Trim Assembly. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Smart Key. Repair procedures
Smart Key Smart Key Code Saving 1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. 2. Select the vehicle model and then do ...