Hyundai Santa Fe (DM): Fuel filler lid
Trailing Arm. Repair procedures Transaxle Oil Temperature Sensor. Repair procedures Tire replacement
1. Before closing the hood, check the following: All filler caps in engine compartment must be correctly installed. Gloves, rags or any other combustible material must be removed from the engine compartment. ...
Closing the hood
The fuel filler lid must be opened from inside the vehicle by pulling the fuel filler lid opener lever located on the driver’s door. ✽ NOTICE If the fuel filler lid will not open because ice ...
Opening the fuel filler lidSee also:
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
If the tire is worn evenly, a tread wear indicator will appear as a solid band across the tread. This shows there is less than 1/16 in. (1.6 mm) of tread left on the tire. Replace the tire when this happens. ...
