Hyundai Santa Fe (TM): Crankcase Emission Control System
Schematic diagrams
Schematic Diagram |
1. PCV Valve 2. Breather hose 3. Air intake hose |
4. Intake maifold 5. Air breather hose 6. Cylinder block |
Positive Crankcase Ventilation (PCV) Valve. Description and operation
Description |
Pressure Regulating Valve (PRV) is installed to prevent the over pressure of
combustion gas through the piston ring and onto the crankcase.
Operation Principle |
Engine Condition |
Stop |
Idle or Deceleration |
Normal operating condition |
Accelerating in the high load area |
Intake manifold pressure |
0 |
High |
Appropriate |
Low |
PRV (Diaphragm) |
Full open |
A little open |
Appropriate open |
Considerable open |
Amount of blow-by gas |
0 |
A little |
Middle |
A lot |
Diaphragm component part |
|
Positive Crankcase Ventilation (PCV) Valve. Repair procedures
Removal |
1. |
Remove the cylinder head cover.
(Refer to Engine Mechanical System - "Cylinder Head Cover")
|
Installation |
1. |
Install in the reverse order of removal.
|
Crankcase Check Valve. Repair procedures
Removal and Installation |
|
1. |
Disconnect the battery (-) terminal.
|
2. |
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
|
3. |
Remove the drive belt.
(Refer to Drive Belt System - "Drive Belt")
|
4. |
Remove the compressor mounting bolts.
(Refer to Heating, Ventilation and Air Conditioning - "Compressor")
|
5. |
Disconnect the crankcase check valve hose (A) and then remove the crankcase
check valve (B).
|
Schematic diagrams
Schematic Diagram ...Evaporative Emission Control System
Description and operation Description Evaporative Emission Control System prevents fuel vapor stored in fuel tank from vaporizing into the atmosphere. When the fuel evaporates in the fuel tank, the vapor ...See also:
Engine Room Under Cover. Components and
Components Location
Components 1. Under Cover 2. Side Cover (RH) 3. Side Cover (LH) ...
Ladder Frame. Repair procedures
Removal • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. • Mark all wiring and hoses to avoid ...
Input Speed Sensor. Description and Operation
Description Input speed sensor (A) is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the Transaxle Control Module(TCM). The sensor ...