Hyundai Santa Fe: Crankshaft Position Sensor (CKPS). Description and Operation - Engine Control System - Engine Control/Fuel SystemHyundai Santa Fe: Crankshaft Position Sensor (CKPS). Description and Operation

Hyundai Santa Fe DM 2013-2018 Service Manual / Engine Control/Fuel System / Engine Control System / Crankshaft Position Sensor (CKPS). Description and Operation

Description

Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the If there is no CKPS signal input, the engine may stop because of CKPS signal missing. This sensor is installed on the cylinder block or the transaxle housing and generates alternating current by magnetic flux field which is made by the sensor and the target wheel when engine runs.
The target wheel consists of 58 slots and 2 missing slots on 360 degrees CA (Crank Angle).


Engine Coolant Temperature Sensor (ECTS). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals ...

Crankshaft Position Sensor (CKPS). Troubleshooting
Wave Form ...

See also:

Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Specifications Direct control VFS[T/CON] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81~500.14 (0.1~5.1,1.42~72.54) Current value(mA) 50~850 Internal resistance(Ω) ...

Brake fluid
Checking the brake fluid level Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the reservoir cap and ...

Starter. Components and Components Location
Components 1. Front housing 2. Starter solenoid assembly 3. Lever 4. Lever packing 5. Planet shaft assembly 6. Planetary gear assembly 7. Packing 8. Shield 9. Amature assembly 10. Brush holder assembly ...