Hyundai Santa Fe: Curtain Airbag (CAB) Module. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module. Repair procedures

Removal

1.	Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.

2.	Remove the roof trim.

3.	Disconnect the curtain airbag harness connector (A).

4.	After loosening the mounting bolts and nuts remove the curtain airbag.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes.

Tighten the curtain airbag mounting bolts and nuts.

Tightening torque

Bolt : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Nunt : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

•	Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.

4.	Connect the curtain airbag connector.

5.	Install the roof trim.

6.	Reconnect the battery negative cable.

After installing the curtain airbag (CAB), confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Curtain Airbag (CAB) Module. Components and Components Location

Components ...

Knee Airbag (KAB) Module. Description and Operation

Description The Knee Airbag (KAB) is installed inside the crash pad lower panel and protects the driver in the event of a frontal crash. The SRSCM determines if and when to deploy the KAB. Never attempt ...