Hyundai Santa Fe: DBC Switch. Repair procedures
Inspection
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the crash pad lower panel.
|
| 3. |
Remove the crash pad side switch assembly (A) after loosening
the screws.
|
| 4. |
Check the continuity between the switch terminals as the DBC switch
is engaged.
|
DBC Switch. Description and Operation
Description The DBC function is the acronym word of Downhill Brake Control function. When a vehicle goes down the hill, just pushing the DBC switch enables the car to keep its vehicle's speed at a ...
Steering Angle Sensor. Description and Operation
Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction ...
See also:
LCD Display Control
The LCD display modes can be changed by using the control buttons on the steering wheel. (1) : MODE button for changing modes (2) : MOVE button for changing items (3) : SELECT/RESET button for setting ...
Malfunction Indicator Lamp (MIL)
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction with the emission ...
Hood Lift. Repair procedures
Replacement • When removing and installing the hood lifter, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdriver, lift the socket clips (A) up slightly on ...
