Hyundai Santa Fe: ESC(Electronic Stability Control) System
- Components and Components Location
- Description and Operation
- Schematic Diagrams
- Troubleshooting
- EBD(Electronic Brake-force Distribution). Description and Operation
- ESC Control Module. Components and Components Location
- ESC Control Module. Repair procedures
- Front Wheel Speed Sensor. Components and Components Location
- Front Wheel Speed Sensor. Repair procedures
- Rear Wheel Speed Sensor. Components and Components Location
- Rear Wheel Speed Sensor. Repair procedures
- Yaw-rate and G Sensor. Description and Operation
- Yaw-rate and G Sensor. Repair procedures
- ESC OFF Switch. Description and Operation
- ESC OFF Switch. Repair procedures
- DBC Switch. Description and Operation
- DBC Switch. Repair procedures
- Steering Angle Sensor. Description and Operation
Parking Brake Cable. Repair procedures
Removal Parking brake pedal Type 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the parking brake cable mounting nut (A) and bolts(B). ...
Components and Components Location
Components 1. HECU module 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. Yaw rate & Lateral G sensor 5. ABS Warning lamp 6. Parking brake/EBD warning lamp 7. ESC Function/Warning lamp 8. ...
See also:
Reset items
Items should be reset after the battery has been discharged or the battery has been disconnected. Auto up/down window (See section 4) Sunroof (See section 4) Trip computer (See section 4) Climate control ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Specifications
Specifications Direct control VFS[OD/C] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14~9.81 (5.1~0.1,72.54~1.42) Current value(mA) 50~850 Internal resistance(Ω) ...
Hood Latch. Repair procedures
Replacement [Hood upper latch assembly] 1. After loosening the mounting bolts, then remove the hood upper latch assembly (A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 2. Install ...
