Hyundai Santa Fe: Description and Operation - Back View Camera System - Body Electrical SystemHyundai Santa Fe: Description and Operation

Description

Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.
This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.

Schematic Diagrams
Circuit Diagram ...

Repair procedures
Removal 1. Remove the tailgate trim. 2. Remove the tailgate back panel. 3. Disconnector the connector (A) from the back view camera. 4. Remove the back view camera (B) after loosening the screws (2EA). ...

See also:

Hands Free Mic. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Seperate the handsfree mic (A) from the roof trim. 3. Remove the handsfree mic (B) after disconnecting the handsfree mic connector (A). 4. ...

Fuel Filter. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). 3. Release the fixing hooks, and then remove the fuel sender (A). 4. Release ...

Knee Airbag (KAB) Module. Description and Operation
Description The Knee Airbag (KAB) is installed inside the crash pad lower panel and protects the driver in the event of a frontal crash. The SRSCM determines if and when to deploy the KAB. Never attempt ...