Hyundai Santa Fe: Disarmed stage - Theft-alarm system - Features of your vehicleHyundai Santa Fe: Disarmed stage

Using the smart key

The system will be disarmed when the doors are unlocked by pressing the unlock button on the smart key or pressing the lock/unlock button of the front outside door handle with the smart key in your possession.

After unlocking the doors, the hazard warning lights and chime will operate twice to indicate that the system is disarmed.

Смотрите подробности buy sim2fly esim на сайте.

After unlocking the doors, if any door is not opened within 30 seconds, the system will be rearmed.

Using the transmitter

The system will be disarmed when the doors are unlocked by pressing the unlock button on the transmitter.

After unlocking the doors, the hazard warning lights will blink twice to indicate that the system is disarmed.

After unlocking the doors, if any door is not opened within 30 seconds, the system will be rearmed.

Using the mechanical key

The system will be disarmed when the doors are unlocked with the mechanical key.

✽ NOTICE

If you lock or unlock the doors by using the mechanical key, the hazard warning light and chime sound won't operate.

✽ NOTICE

  • Avoid trying to start the engine while the alarm is activated. The vehicle starting motor is disabled during the theft-alarm stage.
  • If you lose your keys, contact your authorized HYUNDAI dealer.

CAUTION

Do not change, alter or adjust the theft-alarm system because it could cause the theft-alarm system to malfunction and should only be serviced by an authorized Hyundai dealer.

Malfunctions caused by improper alterations, adjustments or modifications to the theft-alarm system are not covered by your vehicle manufacturer warranty.

Theft-alarm stage
The alarm will be activated if any of the following occurs while the system is armed. A door is opened without using the transmitter, smart key or mechanical key. The tailgate is opened without using the ...

See also:

Rear Shock Absorber. Repair procedures
Removal 2WD 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

Components and Components Location
Components 1. Piston ring 2. Snap ring 3. Piston 4. Connecting rod 5. Connecting rod upper bearing 6. Piston pin 7. Connecting rod lower bearing 8. Connecting rod bearing cap 9. Ladder frame 10. Oil filter ...

Seatback angle
To recline the seatback: 1. Lean forward slightly and lift up the seatback recline lever. 2. Carefully lean back on the seat and adjust the seatback of the seat to the position you desire. 3. Release ...