Hyundai Santa Fe: Electronic Brake force Distribution (EBD) System Warning Light - Warning lights - Warning and indicator sights - Features of your vehicleHyundai Santa Fe: Electronic Brake force Distribution (EBD) System Warning Light

These two warning lights illuminate at the same time while driving:

These two warning lights illuminate at the same time while driving:

• When the ABS and regular brake system may not work normally.
In this case, have your vehicle inspected by an authorized HYUNDAI dealer.

WARNING - Electronic Brake force Distribution (EBD) System Warning Light

When both ABS and Parking Brake & Brake Fluid Warning Lights are on, the brake system will not work normally and you may experience an unexpected and dangerous situation during sudden braking.

In this case, avoid high speed driving and abrupt braking.

Have your vehicle inspected by an authorized HYUNDAI dealer as soon as possible.

✽ NOTICE - Electronic Brake force Distribution (EBD) System Warning Light

When the ABS Warning Light is on or both ABS and Parking Brake & Brake Fluid Warning Lights are on, the speedometer, odometer, or tripmeter may not work. Also, the EPS Warning Light may illuminate and the steering effort may increase or decrease.

In this case, have your vehicle inspected by an authorized HYUNDAI dealer as soon as possible.

Anti-lock Brake System (ABS) Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is a malfunction ...

Electronic Power Steering (EPS) Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction with the EPS. ...

See also:

Tail Gate Back Panel. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Injector. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the injector terminals 1 and 2. 4. Check that the resistance is within the specification. ...

Fuel Pressure Regulator. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump�) 2. Release the fixing hooks, and then remove the regulator cup (A). 3. Remove the fuel pressure regulator (A). Installation ...