Hyundai Santa Fe: Output Speed Sensor. Description and Operation
Description
The output speed sensor (A) is a vital unit that measures the rate of
rotation of the transaxle's turbine shaft and output shaft, and delivers the
readings to the Transaxle Control Module(TCM). The sensor provides critical
input data that's used in feedback control, damper clutch control, gear setting
control, line pressure control, clutch activation pressure control, and sensor
fault analysis.
Input Speed Sensor. Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. 2. Disconnect ...
Output Speed Sensor. Specifications
Specifications ▷ Type: Hall effect sensor Operation condition (°C)°F ((-)40~150)) -40~302 Air gap(mm)in. (0.25~0.70) 0.0098~0.0276 Output voltage (V) High 1.18~1.68 Low 0.59~0.84 ...
See also:
Electronic Stability Control (ESC) OFF Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you deactivate the ...
Speakers. Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector is connected ...
Air cleaner
Filter replacement It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed air. 1. Loosen the ...
