Hyundai Santa Fe: Electronic Stability Control (ESC) OFF Indicator Light
This indicator light illuminates:
- Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It illuminates for approximately 3 seconds and then goes off. - When you deactivate the ESC system by pressing the ESC OFF button.
For more details, refer to “Electronic Stability Control (ESC)” in chapter 5.
Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is a malfunction ...
ECO Indicator Light
This indicator light illuminates: When you activate the active ECO system by pressing the ACTIVE ECO button. For more details, refer to “Active ECO System” in chapter 5. ...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Door Scuff Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
Output Speed Sensor. Schematic Diagrams
Circuit Diagram ...
