Hyundai Santa Fe: Engine Mounting. Components and Components
Location
Components
|
1. Transaxle mounting bracket 2. Roll rod bracket |
3. Engine mounting bracket 4. Engine mounting support bracket |
Engine Room Under Cover. Repair procedures
Removal and Installation 1. Unfasten the fasteners (A) and bolts (B) then remove the engine room under cover (C). Tightening torque: 7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft) 2. Remove the engine ...
Engine Mounting. Repair procedures
Removal and Installation Roll road Bracket 1. Remove the roll road bracket(A). Tightening torque Bolt (B) : 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft) Bolt (C) : 107.9 ~ 127.5 N.m (11.0 ~ 13.0 ...
See also:
DBC Switch. Repair procedures
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the crash pad side switch assembly (A) after loosening the screws. 4. ...
Windshield Wiper-Washer Switch. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A) after loosening 3 screws. 3. Disconnect the connector (A). 4. If necessary of removing ...
Torque Converter Control Solenoid Valve (T/CON_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
