Hyundai Santa Fe: Engine Room Under Cover. Repair procedures - Engine And Transmission Assembly - Engine Mechanical SystemHyundai Santa Fe: Engine Room Under Cover. Repair procedures

Removal and Installation

1.
Unfasten the fasteners (A) and bolts (B) then remove the engine room under cover (C).

Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

2.
Remove the engine room side cover(A).

Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

[RH]

[LH]

3.
Install in the reverse order of removal.

Engine Room Under Cover. Components and Components Location
Components 1. Under Cover 2. Side Cover (RH) 3. Side Cover (LH) ...

Engine Mounting. Components and Components Location
Components 1. Transaxle mounting bracket 2. Roll rod bracket 3. Engine mounting bracket 4. Engine mounting support bracket ...

See also:

Inhibitor Switch. Description and Operation
Description Inhibitor Switch monitors the lever's position(P, R, N, D) and is used to control gear setting signals. ...

Record your key number
The key code number is stamped on the bar code tag attached to the key set. Should you lose your keys, this number will enable an authorized HYUNDAI dealer to duplicate the keys easily. Remove the bar ...

Tail Gate Weatherstrip. Repair procedures
Replacement 1. Remove the tail gate weatherstrip (A). • Do not apply sealant to the body. 2. Install in the reverse order of removal. • Install the weatherstrip aligned with canter line (B). ...