Hyundai Santa Fe: ESC operation off - Electronic stability control (ESC) - Brake system - Driving your vehicleHyundai Santa Fe: ESC operation off

ESC OFF state

This car has 2 kinds of ESC off states.

This car has 2 kinds of ESC off states.

If the engine stops when ESC is off, ESC remains off. Upon restarting the engine, the ESC will automatically turn on again.

• ESC off state 1

To cancel ESC operation, press the ESC OFF button (ESC OFF OFF ) illuminates). At this state, the) shortly (ESC OFF indicator light (ESC OFF engine control function does not operate. It means the traction control function) illuminates). At this state, the engine control function does not operate. It means the traction control function does not operate. Brake control function only operates.

• ESC off state 2

To cancel ESC operation, press the ESC OFF button (ESC OFF light (ESC OFF ) illuminates and ESC) for more than 3 seconds. ESC OFF indicator light (ESC OFF OFF warning chime will sound. At this state, the engine control function and brake) illuminates and ESC OFF warning chime will sound. At this state, the engine control function and brake control function do not operate. It means the car stability control function does not operate any more.

ESC operation
ESC ON condition When the ignition is turned ON, ESC and ESC OFF indicator lights illuminate for approximately 3 seconds, then ESC is turned on. Press the ESC OFF button for at least half a second after ...

Indicator light
When ignition switch is turned to ON, the indicator light illuminates, then goes off if the ESC system is operating normally. The ESC indicator light blinks whenever ESC is operating or illuminates when ...

See also:

Transaxle Oil Temperature Sensor. Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

Seat belt warning (for driver’s seat)
The driver's seat belt warning light and chime will activate to the following table when the ignition switch is in "ON" position. *1Warning pattern repeats 11 times with an interval of 24 ...

Oil Pressure Switch. Repair procedures
Inspection 1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. Check the continuity between the terminal and the body ...