Hyundai Santa Fe: Operation of the rear parking assist system - Rear parking assist system - Features of your vehicleHyundai Santa Fe: Operation of the rear parking assist system

Operating condition

  • This system will activate when the indicator on the rear parking assist OFF button is not illuminated.
    If you desire to deactivate the rear parking assist system, press the rear parking assist OFF button again. (The indicator on the button will illuminate.) To turn the system on, press the button again. (The indicator on the button will go off.)
  • This system will activate when backing up with the ignition switch ON.
    If the vehicle is moving at a speed over 10 km/h (6 mph), the system may not be activated correctly.
  • The sensing distance while the rear parking assist system is in operation is approximately 47 in. (120 cm).
  • When more than two objects are sensed at the same time, the closest one will be recognized first.

Types of warning sound

  • When an object is 47 in. to 24 in. (120 cm to 61 cm) from the rear bumper: Buzzer beeps intermittently.
  • When an object is 23 in. to 12 in. (60 cm to 31 cm) from the rear bumper: Buzzer beeps more frequently.
  • When an object is within 11.8 in. (30 cm) of the rear bumper:

Buzzer sounds continuously.

Rear parking assist system
The rear parking assist system assists the driver during backward movement of the vehicle by chiming if any object is sensed within a distance of 47 in. (120 cm) behind the vehicle. This system is a supplemental ...

Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when: 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with foreign matter, ...

See also:

Operating door locks from inside the vehicle
With the door lock button To unlock a door, push the door lock button(1) to the “Unlock” position. The red mark (2) on the button will be visible. To lock a door, push the door lock button(1) to the ...

Schematic Diagrams
Circuit Diagram (1) Circuit Diagram (2) ...

Water Temperature Control Assembly. Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Loosen the drain plug and drain the engine coolant. 3. Remove the radiator upper hose and lower hose. 4. Disconnect the connectors and then remove ...