Hyundai Santa Fe (TM): Fender - Body (Interior and Exterior)Hyundai Santa Fe (TM): Fender

Components and components location

Component Location

1. Fender assembly

Repair procedures

Replacement
  
•
When removing the fender, wrap protective tape around a screwdriver or remover not to damage components
•
Put on gloves to prevent hand injuries
  
•
When removing the clips, use a clip remover.
1.
Remove the front bumper.
(Refer to Front Bumper - "Front Bumper Assembly")
2.
Loosen the mounting screws and then remove the front bumper side mounting bracket (A).
3.
Remove the fender side cover (A).
4.
Remove the DRL (Daytime Running Lights) assembly.
(Refer to Body Electrical System - "DRL (Daytime Running Lights)")
5.
Remove the front wheel guard.
(Refer to Body Side Molding - "Front Wheel Guard")
6.
Remove the fender garnish.
(Refer to Body Side Molding - "Fender Garnish.")
7.
Using a screwdriver or remover, remove the delta garnish (A).
8.
Loosen the mounting bolts remove the fender assembly (A).
Tightening torque :
(B) : 7.7 - 11.6 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)
(C) : 7.8 - 10.8 N.m (0.8 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)

9.
To install, reverse removal procedure.
  
•
Replace any damaged clips (or pin-type retainers).
Special service tools
Special Service Tools Tool (Number and name) Illustration Use 09880 - 4F000 Hog ring clip installer Hog ring clip installation ...

Hood
Repair procedures Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt. 2. Adjust the hood height by moving ...

See also:

Checking the engine oil level
Type A Type B 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for ...

Rearview camera
The rearview camera will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R position. This system is a supplemental system that shows behind the vehicle through ...

Air intake control
This is used to select the outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button. Recirculated air position Type A, B The indicator ...