Hyundai Santa Fe: Filler-Neck Assembly. Repair procedures
Removal
| 1. |
Lift the vehicle.
|
| 2. |
Disconnect the fuel filler hose (A).
|
| 3. |
Disconnect the ventilation tube quick-connector ( B).
|
| 4. |
Open the fuel filler door and unfasten the filler-neck assembly
mounting screw (A).
|
| 5. |
Remove the rear-LH wheel, tire and the inner wheel house.
|
| 6. |
Remove the filler-neck assembly from the vehicle after removing
the bracket mounting nut (A).
|
Installation
| 1. |
Install in the reverse order of removal.
|
Fuel Line. Repair procedures
Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”) ...
Accelerator Pedal. Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (C), the bolt (B) and ...
See also:
Opening the tailgate
The tailgate is locked or unlocked when all doors are locked or unlocked with the key, transmitter, smart key or central door lock switch. If unlocked, the tailgate can be opened by pressing the handle ...
Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be held to ...
Seatback angle
To recline the seatback: 1. Pull up the seatback recline lever. 2. Hold the lever and adjust the seatback of the seat to the position you desire. 3. Release the lever and make sure the seatback is locked ...
